VentureCraft Go-Dap TT Betriebsanweisung PDF herunterladen (Seite 4)

2. Charging the Built-in Battery of this Product

Connect the USB micro B connector on the rear panel of

this product and computer or the USB charging adapter

supplied with iPod/iPhone by using the supplied USB cable.

The built-in battery is charged by setting the toggle

switch (L) on the front panel to "

" or " "

mode. (Make sure the power is OFF.)

During charging, the charging status indicator LED

located on the side panel will light up.

When the built-in battery of this product has been fully

charged, it will automatically start charging iPod/iPhone. It

takes approximately 6 hours to fully charge this product.

The charging status LEDs turn off when the USB cable is

disconnected.

Charging status indicator

Charging status LED

Pre charge

○ ●

Charge ○

Complete ●

LED color ○：Orange ●：Green

CAUTION

If both LEDs are o or become o when the USB

cable is connected, immediately disconnect the

USB cable and stop charging.

Please refer to "Troubleshooting" on page 9 of

this User's Guide and reset before reuse.

USB

1 2 3 4 5 6 7 8 9 ... 13 14

Keine Kommentare

VentureCraft Go-Dap TT Betriebsanweisung Seite 4